Commercial Caulking

Commercial Caulking & Sealant Replacement in Sacramento

Failed sealant is one of the most common ways water and air get into a commercial building. We remove it, prep the joint properly, and install new sealant sized for the joint.

Scope of Work

Joints and Sealants We Handle

Expansion & Control Joints

Buildings move with temperature changes and settling. Expansion and control joints let that happen without cracking, but only while the sealant in them stays flexible and bonded.

Tilt-Up Panel Joints

Concrete tilt-up buildings are everywhere in Sacramento-area business parks. The vertical joints between panels are long runs of sealant that eventually need replacing.

Window, Door & Storefront Perimeters

Perimeter joints around openings are a frequent source of leaks and drafts. New sealant keeps water and air where they belong.

Floor Joints & Slab Cracks

Joint filling and crack treatment on concrete floors, including as part of an epoxy floor system.

Done Right

How We Replace Sealant

A sealant joint only works when it’s built correctly: the right depth, bonded on two sides, and made with a sealant suited to the joint’s movement and the materials it touches.

Matched to the joint: silicone, polyurethane and hybrid sealants each have strengths. We choose based on joint movement, substrate, UV exposure and whether the joint will be painted.

  1. Inspect

    Identify failed joints, the cause of failure, and any substrate damage.

  2. Remove

    Cut out the old sealant completely, not just the visible bead.

  3. Clean & Prime

    Clean the joint faces and prime where the sealant and substrate require it.

  4. Backer Rod

    Install backer rod to set the right sealant depth and prevent three-sided adhesion.

  5. Seal & Tool

    Install the new sealant and tool it for full contact and a clean, professional finish.

Signs It’s Time

When to Replace Commercial Caulking

  • Sealant cracked, split or chalky
  • Bead pulled away from one side of the joint
  • Hardened sealant that no longer flexes
  • Missing sections or open gaps
  • Water stains on interior walls near joints or windows
  • Drafts or daylight around frames

Sacramento’s hot summers and wet winters are hard on exterior sealant. If your building’s joints haven’t been looked at in years, it’s worth an inspection. Pair it with waterproofing to close up the whole envelope.

Caulking Questions

How do I know if my building’s caulking has failed?

Look for sealant that’s cracked, shrunken, hardened, pulled away from one side of the joint, or missing. Water stains on interior walls near windows or joints, drafts, and gaps you can see light through are other signs.

Can you just caulk over the old sealant?

No. Caulking over failed sealant traps the problem and the new bead won’t bond properly. We remove the old sealant, clean and prep the joint, and install new backer rod and sealant.

Do you work with general contractors and property managers?

Yes. We bid caulking and sealant scopes for GCs, property managers and building owners, and we can combine it with floor coating work on the same project.

Capitol City Sealant logo

Get Your Joints Looked At

Send us the building type, approximate linear footage if you know it, and photos of the problem areas.

Free Estimate