Residential Garage Floors

Garage Epoxy Flooring in Sacramento

Full-broadcast flake epoxy garage floors installed over diamond-ground concrete. Built for oil drips, hot tires, dropped tools and Sacramento summers.

Why It Matters

Why a Garage Floor Kit Doesn’t Last

Most DIY garage kits come with a jug of etching solution and a roller. They look good for a season, then hot tires start lifting the coating and it peels in sheets. That isn’t bad luck. The coating was never properly bonded to the concrete.

A garage slab takes a beating: tires that come in hot off the freeway, oil and coolant drips, dropped tools, rolling jacks and toolboxes. In the Sacramento area the heat makes all of that harder. A garage floor that lasts starts with mechanical prep and a multi-coat system made for vehicle traffic.

That’s what we install. Every garage we coat is diamond ground with a dust extractor, repaired, and built up in layers, not painted.

Blue-gray flake epoxy garage floor installed by Capitol City Sealant
Finished full-broadcast flake garage floor.
What’s Included

Every Garage Floor Includes

  1. Inspection & Estimate

    We check the slab for cracks, spalls, oil saturation and any old coating, then give you a written estimate.

  2. Oil & Contaminant Treatment

    Stains and buildup are cleaned and treated so they don’t interfere with the bond.

  3. Diamond Grinding

    A walk-behind diamond grinder opens the concrete surface. A vacuum dust extractor runs with the grinder the whole time.

  4. Crack & Joint Repair

    Cracks, pits and damaged areas are filled so they don’t show through.

  1. Epoxy Base Coat

    A tinted epoxy base coat is rolled out over the clean, profiled slab.

  2. Full Flake Broadcast

    Decorative vinyl flake is broadcast into the wet base coat until the floor is fully covered.

  3. Scrape & Clear Topcoat

    Loose flake is scraped and removed, then a clear topcoat seals the floor and gives it its finish.

  4. Walk-Through & Care Guide

    We walk the finished floor with you and go over cure times and cleaning.

Real Garage, Real Results

Before, During and After

Garage floor with oil stains and tire marks before epoxy, grinder stagedBefore
The same garage floor after full diamond grindingGround
The same garage finished with blue-gray flake epoxyFinished
Tan flake epoxy floor in a large Sacramento-area garage
A tan and gray flake blend in a large garage.
Built for How You Use It

Who Our Garage Floors Are For

  • Daily drivers. A floor that handles hot tires, road grime and winter rain tracked in.
  • Car people. A clean, bright floor that makes the garage feel like a showroom and cleans up easily.
  • Home gyms and workshops. Durable under equipment, and spills wipe right up.
  • Sellers and landlords. A finished garage floor is an easy, visible upgrade before listing or between tenants.

Flake comes in a range of color blends, from cool blue-grays to warm tans. We’ll bring samples so you can see them against your walls and lighting. Want a different look? See our flake and solid color systems.

Care

Keeping It Looking New

An epoxy garage floor is low maintenance. Sweep or dust-mop regularly, since grit is what dulls a topcoat over time. Mop with warm water and a mild cleaner, and wipe up oil, brake fluid or chemicals when you see them. Skip harsh solvents and abrasive pads.

We’ll leave you with care instructions for your specific system at the final walk-through.

Garage Floor Questions

How long before I can walk or park on my new garage floor?

It depends on the coating system and the temperature during the install. We give you exact walk-on and drive-on times for your floor before we start, so you can plan around them.

Will the oil stains show through the new floor?

Surface oil is cleaned and ground off during prep. Deep stains are treated before coating, and a full-broadcast flake floor hides the slab completely. Heavily soaked areas sometimes need extra work, and we’ll tell you during the walk-through if yours does.

Can you coat over my old epoxy or garage paint?

Not if it’s peeling, and we won’t layer new coating over a failing one. Old coatings are ground off down to sound concrete so the new system bonds to the slab itself.

Is a flake floor slippery?

Flake floors have a light texture that gives better grip than a smooth solid coat. If you want more traction, for example on a slope or where the floor gets wet, a slip-resistant additive can go in the topcoat.

Do I need to empty my garage?

Yes. The floor has to be completely clear for grinding and coating. We’ll go over timing so you know when to clear it and when you can move back in.

Capitol City Sealant logo

Let’s Get Your Garage Floor Done

Send us a few details and photos of your garage. We’ll set up a time to look at the slab and give you a written estimate.

Free Estimate